Technical specifications

VEHICLE IDENTIFICATION DATA CHASSIS MARKING fig. 1

It is printed on the passenger compartment floor, near the right-hand front seat.

It can be reached by lifting the special flap in the carpeting and includes the following data:

Ц vehicle model ZFA 223000;

Ц chassis number.

ENGINE MARKING

ENGINE MARKING

The marking is stamped on the cylinder block and includes the model and the serial number.

MODEL PLATE

MODEL PLATE

The plate A-fig. 2-3, is applied to the front engine cross member.

The plate fig. 4bears the following identification data:

The plate fig. 4bears the following identification data:

B - Homologation number

C - Vehicle type code

D - Chassis number

E - Maximum vehicle weight fully loaded

F - Maximum vehicle weight fully loaded with trailer.

G - Maximum vehicle weight on front axle.

H - Maximum vehicle weight on rear axle

I - Engine type

L - Body version code

M - Spare part code

M - Smoke opacity index (for diesel engines).

BODYWORK PAINT IDENTIFICATION PLATE

The plate fig. 5 is applied inside the bonnet.

It bears the following data:

A - Paint manufacturer

B - Colour name

C - Fiat colour code

D - Respray and touch up code.

Engine codes - bodywork versions

See also:

Brake Assist System (BAS)
The BAS is designed to optimize the vehicleТs braking capability during emergency braking maneuvers. The system detects an emergency braking situation by sensing the rate and amount of brake appli ...

Electronic Speed Control
When engaged, the Electronic Speed Control takes over accelerator operations at speeds greater than 25 mph (40 km/h). The Electronic Speed Control buttons are located on the right side of the steer ...

Bodywork
PROTECTION FROM ATMOSPHERIC AGENTS The main causes of rust are: Ц atmospheric pollution Ц salt and humidity in the atmosphere (coastal or very hot and humid areas) Ц environmental conditions that ...