See also:

Rear light unit
To change the bulb, proceed as follows: ❒ from inside the car, remove the upper plastic cover (A) with the screwdriver provided to reach fastener (B); ❒ from inside the boot, fit ...

Blades
Periodically clean the rubber part using special products; TUTELA PROFESSIONAL SC 35 is recommended. If the rubber blades are bent or worn they should be replaced. In any case they should be chan ...

Inflating procedure
Proceed as follows: ❒ Position the involved wheel with the inflation valve (A) set as shown in the figure, then pull up the handbrake; ❒ Screw the filler hose (B) to the cylinder ...