Any failure is indicated by cluster warning light
coming on together with the message
on the reconfigurable multifunction display (where required) (see section “Warning
lights and messages”). In the event of electric power steering system failure, the
car can be driven with mechanical steering.
IMPORTANT In some circumstances, factors independent from the electric power
steering could cause the illumination of the warning light
on the cluster.
We suggest to stop immediately the car, turn off the engine for about 20 seconds
and then re-start the car. If the warning light
stays on together with the message
on the reconfigurable multifunction display (where required), contact Fiat Dealership.
IMPORTANT The steering may become slightly stiff following parking manoeuvres including a great deal of steering. This is normal and caused by a system to prevent motor overheating. No servicing is required. The electrical power steering system will return to normal operation the next time the car is used.
WARNING
It is absolutely forbidden to carry out whatever after-market operation involving steering system or steering column modifications (e.g.: installation of anti-theft device) that could badly affect performance and safety, cause the lapse of warranty and also result in non-compliance of the car with homologation requirements.
WARNING
Always switch the engine off, remove the key from the starting device and actuate the steering lock before carrying out any maintenance operation, especially when the wheels are raised from the ground. In case this is not possible (e.g. when the key must be in MAR position or the engine running), remove the electric power steering main fuse before carrying out any maintenance operation.
See also:
Environment and economy
The Fiat Doblò will be launched with four engines with 5 or 6 speed
gearboxes, all designed and made by FPT - Fiat Powertrain Technologies:
1.3 Multijet II 16v - 90 HP (Euro 4);
1.6 Multij ...
Enhanced Accident Response System
In the event of an impact causing airbag deployment, if the communication network
remains intact, and the power remains intact, depending on the nature of the event
the ORC will determine whether ...
Main beam headlights
To change the halogen bulb, proceed as follows:
1) Remove the protection cover Cfig.
18 turning it counterclockwise;
2) Release clip A-fig. 19, remove connector B and remove the bulb C.
...