Turn the ignition key to STOP.
At the following starting operation (key at MAR), the sensor will not be reactivated even is the stalk is on (B). In this event, to activate the rain sensor, you have to move the stalk to (A) or (C) and then again to (B).
When the rain sensor is again activated in this way, at least one windscreen wiper stroke occurs, even if the windscreen is dry.
The rain sensor is able to recognize and automatically adjust itself in the presence of the following particular conditions:
❒ impurities on the controlled surface (salt, dirt, etc.);
❒ straks of water caused by worn wiper blades;
❒ difference between day and night.
Do not activate the rain sensor when washing the car in an automatic washing station.
In the event of ice on the windscreen, make sure to have disconnected the device.
WARNING
Make sure the device is off when cleaning the windscreen.
See also:
Power Steering
The standard power steering system will give you good vehicle response and increased
ease of maneuverability in tight spaces. The system will provide mechanical steering
capability if power assist ...
Fuel reserve
Turning the ignition key to MAR, the warning light on the instrument panel shall
turn on but it should go off after a few seconds.
The warning light turns on (on certain versions together with ...
The signs to help you drive correctly
The signs you see on this page are very important. They highlight those parts
of the handbook where, more than anywhere else, you should stop for a minute and
read carefully.
As you can see, each ...