After fuel has been added, the vehicle diagnostic system can determine if the fuel filler cap is possibly loose, improperly installed, or damaged. If the system detects a malfunction, the “gASCAP” message will display in the odometer display. Tighten the gas cap until a clicking sound is heard. This is an indication that the gas cap is properly tightened. Press the odometer reset button to turn the message off. If the problem persists, the message will appear the next time the vehicle is started. This might indicate a damaged cap. If the problem is detected twice in a row, the system will turn on the MIL. Resolving the problem will turn the MIL off.
See also:
Jump starting
If the battery is flat, you can use another battery to start the engine. Its
capacity must be the same or slightly greater than the flat battery.
Proceed as follows fig. 1:
1) Connect positive ter ...
Automatic Transmission — If Equipped
CAUTION!
Damage to the transmission may occur if the following precautions are not
observed:
• Move the shift lever into PARK only after the vehicle has come to a complete stop.
• Shift into o ...
Limited range
Messages will be shown on the display when range falls below 50 km. ...