The TRIP button, located on the right steering column stalk, can be used to display and to reset the previously described values.
• A short button press displays the different values.
• A long button press resets the system and then starts a new trip.
New Trip
To reset:
• Press and hold the TRIP button to reset the system manually.
• When the “Trip distance” reaches 9999.9 miles or kilometers or when the “Travel
time” reaches 99.59 (99 hours and 59 minutes), the system is reset automatically.
• Disconnecting/Reconnecting the battery resets the system.
NOTE: If the reset operation occurs in the presence of the screens concerning
Trip A or Trip B, only the information associated with Trip A or Trip B functions
will be reset.
Start Of Trip Procedure
With the ignition on, press and hold the TRIP button for over one second to reset.
Exit Trip
To exit the Trip function, wait until all the values have been displayed or hold the MENU ESC button for longer than one second.
Briefly press the MENU ESC button to go back to the menu screen or press and hold the MENU ESC (approximately one second) to go back to the main screen without storing settings.
See also:
Annual inspection schedule
For cars with an annual mileage of below 20,000 km (for example about 15,000
km) the following yearly inspection programme is advised:
❒ check tyre conditions/wear and adjust pressure if req ...
Interior Care
Use MOPAR Total Clean or equivalent to clean fabric upholstery and carpeting.
Use MOPAR Total Clean or equivalent to clean vinyl upholstery.
MOPAR Total Clean or equivalent is specifically recommend ...
Cooling System
WARNING!
• When working near the radiator cooling fan, disconnect the fan motor lead
or turn the ignition switch to the OFF position. The fan is temperature controlled
and can start at any time ...