1. Glow Plug Light — If Equipped

The Glow Plug light will flash during engine oil viscosity sensor measurement

The Glow Plug light will flash during engine oil viscosity sensor measurement in cold weather.

During this measurement (up to 10 seconds), the starter will be disabled. If the measured oil viscosity is OK, the light will turn off and the engine will be allowed to crank.

If the measured oil viscosity is too high, engine cranking will be disabled and the light will blink repeatedly until the oil temperature is raised, preferably by an externallypowered electric engine block heater (available from your authorized dealer).

The message Plug In Engine Heater , will be displayed in the instrument cluster when the ambient temperature is below 5°F (-15°C) at the time the engine is shut off as a reminder to avoid possible crank delays at the next cold start.

    See also:

    General Information
    • You can launch the vehicle from a stop in first, second, or third gear. The system will ignore attempts to shift into a higher gear if the engine speed is too low. An audible beep will sound if ...

    “Dualdrive” electric power steering failure
    Turning the ignition key to MAR the warning light on the dial turns on, but it should go off after few seconds. If the warning light stays on (on certain versions together with the message on ...

    Scheduled servicing
    Correct maintenance of the vehicle is essential for ensuring it stays in tiptop condition for a long time to come. This is why Fiat has programmed a series of checks and maintenance operations ev ...