Clean the Rear Park Assist sensors with water, car wash soap and a soft cloth. Do not use rough or hard cloths. In washing stations, clean sensors quickly keeping the vapor jet/high pressure washing nozzles at least 4 in (10 cm) from the sensors. Do not scratch or poke the sensors. Otherwise, you could damage the sensors.
See also:
Roof rack/ski rack
PRESETTING
To use the roof racks you shall remove the caps set in points fig. 136.
Attach the roof rack bar brackets to the fasteners.
IMPORTANT
Always follow the instructions provided with the ki ...
Fuel consumption
The fuel consumption figures given in the table below are determined on the basis
of the homologation tests set down by specific European Directives.
The procedures below are followed for measuring ...
Adding Washer Fluid
The windshield washer fluid reservoir is located in the engine compartment, and
the fluid level should be checked at regular intervals. Fill the reservoir with
windshield washer solvent (not engin ...