If the device has been disengaged for example pressing the brake or clutch pedal, the memorised speed can be reset as follows:
❒ accelerate gradually until reaching a speed approaching the one memorised;
❒ engage the gear selected at the time of speed memorising (4th or 5th or 6th gear);
❒ press the RES button (C).
See also:
18. Malfunction Indicator Light (MIL)
The Malfunction Indicator Light (MIL) is part of an onboard diagnostic system,
called OBDII, that monitors engine and automatic transmission control systems. The
light will illuminate when the k ...
Rear Tail, Stop, Backup And Turn Signal Lamps
1. Open the liftgate.
2. Remove the two screws and remove the tail lamp assembly.
3. Unsnap backplate and separate from the lamp housing.
4. Remove the tail, stop, or turn signal bulbs by pushing ...
Cylinder replacement procedure
To replace the cylinder proceed as follows fig. 16h:
– disconnect connection A; turn counter-clockwise the cylinder to replace and
raise it; fit the new cylinder and turn it clockwise; connect conn ...