Low engine oil pressure

(red)

(red)

EXHAUST OIL

(Multijet versions) (red)

Low engine oil pressure

Turning the ignition key to MAR the warning light turns on, but it should go out as soon as the engine is started.

On certain versions the dedicated message is displayed.

when the vehicle is traveling (on certain versions together with the message on If the warning light when the vehicle is traveling (on certain versions together with the message onturns on when the vehicle is traveling (on certain versions together with the message on the display) stop the engine immediately and contact a Fiat Dealership.

Exhaust oil (Multijet versions)

The warning light with turn on flashing together with the message on the display when the system detects that the engine oil is exhaust.

After the initial signaling, each time the engine is started, the flash cyclically for 3 minutes with intervals of 5 seconds with the warning light warning light will continue to flash cyclically for 3 minutes with intervals of 5 seconds with the warning light OFF until the oil is changed.

If warning light is flashing,

If warning light go to a Fiat Dealership immediately to have the engine oil changed and the warningis flashing, go to a Fiat Dealership immediately to have the engine oil changed and the warning light in the instrument panel will go out.

Failure to do so may adversely affect the validity of the warranty.

    See also:

    Battery
    The battery is of the “Limited maintenance” type: under normal conditions of use the electrolyte does not need topping up with distilled water. CHECKING THE CHARGE fig. 22 The battery charge may b ...

    Body Lubrication
    Locks and all body pivot points, including such items as seat tracks, door hinge pivot points and rollers, liftgate, tailgate, sliding doors and hood hinges, should be lubricated periodically with ...

    Refitting the standard wheel
    Proceed as follows: ❒ Following the procedure described previously, raise the car and remove the spare wheel; ❒ Make sure the contact surfaces between wheel and hub are clean so ...