Enhanced Seat Belt Use Reminder System(BeltAlert )

BeltAlert is a feature intended to remind the driver and front passenger (if equipped with front passenger BeltAlert ) to fasten their seat belts. The feature is active whenever the ignition is on. If the driver or front seat passenger is unbelted, the Seat Belt Reminder Light will turn on and remain on until both front seat belts are fastened.

The BeltAlert warning sequence begins after the vehicle speed is over 5 mph (8 km/h), by blinking the Seat Belt Reminder Light and sounding an intermittent chime.

Once the sequence starts, it will continue for the entire duration or until the respective seatbelts are fastened.

After the sequence completes, the Seat Belt Reminder Light remains illuminated until the respective seat belts are fastened. The driver should instruct all other occupants to fasten their seat belts. If a front seat belt is unbuckled while traveling at speeds greater than 5 mph (8 km/h), BeltAlert will provide both audio and visual notification.

The front passenger seat BeltAlert is not active when the front passenger seat is unoccupied. BeltAlert may be triggered when an animal or heavy object is on the front passenger seat or when the seat is folded flat (if equipped). It is recommended that pets be restrained in the rear seat in pet harnesses or pet carriers that are secured by seat belts, and cargo is properly stowed.

BeltAlert can be enabled or disabled by your authorized dealer. FIAT Group Automobiles does not recommend deactivating BeltAlert .

continue to illuminate while the driver’s or front passenger (if equipped with BeltAlert NOTE: Although BeltAlert has been deactivated, the Seat Belt Reminder Light will continue to illuminate while the driver’s or front passenger (if equipped with BeltAlert ) seat belt remains unfastened.

    See also:

    Fire
    The 2012 Fiat Punto range starts with the 1.2-litre Fire EVO II engine. This 1.2-litre eight-valve has continuously variable valve timing to optimise the opening and closing of the valves. This en ...

    Eobd - engine control system failure
    In normal conditions, turning the ignition key to MAR, the warning light turns on, but it should go off when the engine has started. The initial turning on indicates that the warning light is ...

    Main beam headlights
    To change the halogen bulb, proceed as follows: 1) Remove the protection cover Cfig. 18 turning it counterclockwise; 2) Release clip A-fig. 19, remove connector B and remove the bulb C. ...