Make the height adjustment when the vehicle is stationary.

Always adjust the height of the seat belt to fit the person wearing it. This could greatly reduce the risk of injury in the case of collision.

The belt is adjusted properly when the webbing passes approximately halfway between the edge of the shoulder and the neck. Four height adjustments are possible.

To raise the belt: raise loop A-fig.

8 to the required position.

To lower the belt: press knob B, and at the same time move loop A to the required position.

Check that the seat belt is locked in position by pushing down on loop A without pressing knob B.

After you have made the adjustment, always make sure that the loop is attached firmly in one of the fixed positions and cannot move. To do this, with the button released, exert a further pressure to allow the anchoring device to catch if release did not take place at one of the preset positions.