General information

Turning on of warning light is accompanied by specific message and/or by buzzer sound where provided by instrument panel. These indications are concise and cautionary and shall not be considered as exhaustive and/or as an alternative to the specifications contained in this Owner Handbook which shall always be read through carefully and thoroughly. In case of failure indication always refer to the specifications contained in this section.

IMPORTANT

Failure indications displayed are divided into two categories:

very serious and less serious failures.

Very serious failures are indicated by a warning “cycle” repeated until failure is eliminated.

Less serious failures are indicated by a limited warning “cycle”.

The warning cycle of both failure categories can be stopped by pressing button MODE. The instrument panel warning light will stay on until eliminating the fault.

    See also:

    Seat belts not fastened
    (red) The warning light on the dial turns on glowing steadily with vehicle stationary and driver’s or passenger’s seat belt not fastened correctly. The warning light will turn on flashing when, ...

    Containing running costs and pollution
    Some suggestions which may help you to keep the running costs of the vehicle down and lower the amount of toxic emissions released into the atmosphere are given below. ...

    Jump starting
    If the battery is flat, it is possible to start the engine using an auxiliary battery with the same capacity or a little higher than the flat one. Proceed as follows: ❒ Connect positive ter ...