Center High Mounted Stop Lamp (CHMSL)

1. Remove the two guard caps and the two fastening screws.
2. Remove the center high mounted stop lamp assembly.
3. Disconnect the electric connector.
4. Press the retaining device and open the bulb holder.
5. Remove the snap-fitted bulb to be replaced and replace it.
6. Close the back cap locking it properly.
7. Reinstall the two fastening screws and reinstall the guard caps.

    See also:

    Vehicle Identification Number
    The Vehicle Identification Number (VIN) is found on the left front corner of the instrument panel, visible through the windshield. This number also appears engraved on the right front door sill un ...

    Using the seat belts
    The belt should be worn keeping the chest straight and rested against the seat back. Take hold of the tongue A-fig. 6. Insert it into the buckle B, until you hear it clicks. At removal, if it ja ...

    Installing The LATCH – Compatible ChildRestraint System
    We urge you to carefully follow the directions of the manufacturer when installing your child restraint. Not all child restraint systems will be installed as described here. Again, carefully foll ...