Fuel filler cap

To open the cap, turn it anticlockwise and then remove it.

To open the cap, turn it anticlockwise and then remove it.

During refuelling, secure the cap to the anti-loss device on the flap as shown in the figure.

On certain versions the cap has a keylock: to open it proceed as described below.

Opening the cap with keylock (where provided)

Proceed as follows:

❒ hold the cap still and turn the ignition key anticlockwise;
❒ turn the cap by approximately half a turn anticlockwise and remove it.

The airtight seal of the cap may lead to a slight increase of pressure in the tank. A hissing sound when the cap is removed is therefore quite normal. When refuelling, position the cap on the flap as shown in the figure.

WARNING

Do not put naked flames or lighted cigarettes near the fuel filler hole: danger of fire. Do not bend too close to the hole either so as not to breathe in harmful vapours.

Locking the cap with keylock (where provided)

Proceed as follows:

❒ insert the cap (with the key) and turn it clockwise until it clicks once or more;
❒ turn the key clockwise and remove it. Close the flap.

    See also:

    Activation
    Move the right-hand stalk downwards by one position. The activation of the rain sensor is signalled by a control acquisition “stroke”. IMPORTANT Keep clean the glass in the sensor area. Turning t ...

    General failure indication
    The warning light on the dial comes on when a failure is detected. ...

    Stain Repel Fabric Cleaning Procedure – IfEquipped
    Stain Repel seats may be cleaned in the following manner: • Remove as much of the stain as possible by blotting with a clean, dry towel. • Blot any remaining stain with a clean, damp towel. • Fo ...