The system is preset for deactivating automatically when the trailer electric cable plug is fitted into the car tow hook socket.
Sensors are reactivated when removing the trailer cable plug.
For proper operation, the parking sensors set on the bumpers shall be clean from mud, dirt, snow or ice. When cleaning the sensors, take the utmost care to prevent their damaging; do not use therefore dry or rough clothes. Sensors shall be washed with clean water and car detergent, if required. In washing stations, clean sensors quickly keeping the vapour jet/high pressure washing nozzles at 10 cm at least from the sensors.
WARNING
Parking manoeuvres however are always under the driver’s responsibility. He/she shall always check the absence of people (specially children) or animals in the manoeuvre space. This system is just a help for the driver but he shall never reduce attention during dangerous manoeuvres even if performed at low speed.
See also:
General information
The front and/or side airbags can be triggered if the vehicle is subjected to
strong knocks or impacts underneath, e.g. violent crashes into steps, kerbs or fixed
projections from the ground, fall ...
Rev. counter
The rev. counter shows engine rpm. The needle pointed to the danger area (red
on certain versions) indicates excessive high engine speed. Do not drive for long
periods with the needle in this ar ...
Snow chains
Use of snow chains should be in compliance with local regulations.
Snow chains should only be applied to the driving wheels (front wheels).
Refer to the following table for information on the wheel ...