FASTENERS
3-door versions

Move the seal aside in the points shown in the figure to reach the fasteners.
The rear fasteners are in the areas indicated by the printed
reference mark O on the rear side windows.
To make use of the presetting couplings, remove the retainer (A) by operating on the relevant catch as shown in the figure.
5-door versions

Move the seal aside in the points shown in the figure to reach the fasteners.
The rear fasteners are in the areas indicated by the printed reference mark
on the rear side windows.
Attach the roof rack brackets to the fasteners.
To make use of the presetting couplings, remove the retainer (A) by operating on the relevant catch as shown in the figure.
After few kilometers, check that fastening screws are firmly tightened.
IMPORTANT Follow the instructions provided in the kit to the letter for both versions (3 and 5 doors).
Fitting should be entrusted to skilled personnel.
IMPORTANT Never exceed the max. permissible loads (see section “Technical specifications”).
See also:
Dimensions
Dimensions are expressed in mm.
Height is intended on an unladen vehicle Unladen boot volume (Fiat Doblò
Cargo versions): 3,2 m3.
Unladen boot volume (Fiat Doblò
Passengers Transpo ...
Interior Fuses
The interior fuse panel is part of the Body Control Module (BCM) and is located
on the driver’s side under the instrument panel.
Fuse Panel
...
Liftgate
To unlock the liftgate, use the Remote Keyless Entry (RKE) transmitter or activate
the power door lock switches located on the front door handles.
To open the liftgate, squeeze the liftgate release ...


