Press 
to turn this function on.
Activation is indicated by the turning on of the warning light
on the instrument panel.
This function is timed and switches off automatically after 30 minutes. To cut
out this function press again button .
IMPORTANT Do not apply stickers on the inside of the rear window over the heating filaments to avoid damage that might cause it to stop working properly.
See also:
Rear light unit
To change the bulb, proceed as follows:
❒ from inside the car, remove the upper plastic cover (A) with the screwdriver
provided to reach fastener (B);
❒ from inside the boot, fit ...
To Vary The Speed Setting
When the Electronic Speed Control is set, you can increase speed by pushing the
RES (+) button. If the button is continually pressed, the set speed will continue
to increase until the button is re ...
Tread Wear Indicators
Tread wear indicators are in the original equipment tires to help you in determining
when your tires should be replaced.
1 — Worn Tire
2 — New Tire
These indicators are molded into the bottom o ...