1. Remove portion of the wheel liner to allow hand access to side marker lamp.
2. Rotate the bulb socket counterclockwise, and remove the bulb and socket assembly
from the housing.
3. Pull the bulb from the socket and insert the replacement bulb.
4. Install the bulb and socket assembly into the housing, and rotate the socket
clockwise to lock it in place.
5. Reinstall the wheel liner
See also:
Accessing the rear seats
Versions with one sliding side door (on passenger side)
From passenger’s side: open the sliding side door.
From driver’s side: pull handle Ffig. 59a upwards to tip the seat back.
Once you have let ...
Wind Stop
TheWind Stop installs in the backseat area of the vehicle.
The Wind Stop will not interfere with power top operation.
Therefore, it can remain installed when the top is up. ...
Injection system failure
(Multijet versions - amber)
EOBD SYSTEM FAILURE
(petrol versions - amber)
Injection system failure
Turning the ignition key to MAR the warning light turns on but it should go off
after engine ...