1. Turn the Mode Select Knob (5) to the Sealant Mode position.
2. Uncoil the Sealant Hose (6) and then remove the cap from the fitting at the end of the hose.
3. Place the TIREFIT kit flat on the ground next to the deflated tire.
4. Remove the cap from the valve stem and then screw the fitting at the end of the Sealant Hose (6) onto the valve stem.
5. Uncoil the Power Plug (8) and insert the plug into the vehicle’s 12 Volt power outlet.
NOTE: Do not remove foreign objects (e.g., screws or nails) from the tire.
See also:
Code card (where required)
The car is delivered with two copies of the key and the CODE card which bears
the following:
❒ the electronic code (A) to be used for emergency starting (see “Emergency starting”
in sectio ...
Stopping the engine
Turn the ignition to STOP while the engine is idling. IMPORTANT After a taxing
drive, you should allow the engine to “catch its breath” before turning it off by
letting it idle to allow the temper ...
Suspensions
...