Central door locking system

From the outside

With the doors closed, fit and turn the key in one of the front door locks.

From the inside

With the doors closed, press (to lock) or lift (to unlock) one of the front door knobs. The rear door knobs will lock or unlock only the specific door.

IMPORTANT If one of the doors is not shut properly or there is a failure in the system, the central locking feature will cut out and after some attempts the device stops working for about two minutes. In these 2 minutes, the doors can be locked or unlocked manually. After the two minutes, the control unit is ready to receive commands once more.

If the cause of the failure is removed, the device will start working properly.

    See also:

    Heating
    Proceed as follows: ❒ rotate knob (A) (pointer on -) completely to the right; ❒ turn knob (C) to the required speed; ❒ move knob (D) to: to warm the feet and at the same time ...

    Onboard Diagnostic System – OBD II
    Your vehicle is equipped with a sophisticated onboard diagnostic system called OBD II. This system monitors the performance of the emissions, engine, and automatic transmission control systems. Wh ...

    Magnetic card/ticket slots
    The slots for holding magnetic cards and tickets (phone card, toll slips, etc.) can be found on the central tunnel unit. WARNING Do not travel with the glove compartment open: risk of passenger ...