NOTE: Normal starting of either a cold or a warm engine is obtained without pumping
or pressing the accelerator pedal.
Turn the ignition switch to theAVV (START) position and release it when the engine starts. If the engine fails to start within 10 seconds, turn the ignition switch to the STOP (OFF/LOCK) position, wait 10 to 15 seconds, then repeat the Normal Starting procedure.
See also:
Refitting the standard wheel
Proceed as follows:
❒ Following the procedure described previously, raise the car and remove the
spare wheel;
❒ Make sure the contact surfaces between wheel and hub are clean so ...
Acceleration
Rapid acceleration on snow covered, wet, or other slippery surfaces may cause
the driving wheels to pull erratically to the right or left. This phenomenon occurs
when there is a difference in the ...
Handbrake on
Turning the ignition key to MAR the warning light on the dial turns on, but it
should go off after few seconds. The warning light turns on when the handbrake is
on.
IMPORTANT If the warning lig ...