1. Press the AUTO button on the Automatic Temperature Control (ATC) Panel, the
indicator will illuminate when on.
2. Next, adjust the temperature you would like the system to maintain by adjusting
the temperature control buttons. Once the desired temperature is displayed, the
system will achieve and automatically maintain that comfort level.
3. When the system is set up for your comfort level, it is not necessary to change
the settings. You will experience the greatest efficiency by simply allowing the
system to function automatically.
NOTE:
• It is not necessary to move the temperature settings for cold or hot
vehicles. The system automatically adjusts the temperature, mode and fan speed to
provide comfort as quickly as possible.
• The temperature can be displayed in U.S. or Metric units by selecting the US/M
customer-programmable feature. Refer to the “Electronic Vehicle Information Center
(EVIC) — Customer-Programmable Features” in this section of the manual.
To provide you with maximum comfort in the Automatic mode during cold start-ups, the blower fan will remain on low until the engine warms up. The blower will increase in speed and transition into AUTO mode.
See also:
Recirculation
Move slider (B) to .
This function is particularly useful when the outside air is heavily polluted
(in a traffic jam, tunnel, etc.). However, it is better not to use it for long periods,
especial ...
Exit menu (Exit Menu)
This is the last function that closes the circular setting cycle listed in the
initial menu screen.
Start of journey procedure (reset)
To start a new journey monitored by the “General trip”, wit ...
Low brake fluid level
HANDBRAKE ON (red)
Turning the ignition key to MAR the warning light turns on, but it should go
off after few seconds.
Low brake fluid level
The warning light turns on when the level of the bra ...