A malfunction of the Rear Park Assist sensors or system is indicated, during REVERSE gear engagement, by the instrument panel warning icon.
The warning icon is illuminated and a message is displayed on the multifunction display (if equipped). Refer to “Instrument Cluster Descriptions” in “Understanding Your Instrument Panel” for further information.
The sensors and wiring are tested continuously when the ignition is in the ON/RUN position. Failures are indicated immediately if they occur when the system is ON.
Even if the system is able to identify that a specific sensor is in failure condition, the instrument cluster display shall indicate that the Rear Park Assist system is unavailable, without reference to the sensor in failure condition.
If even a single sensor fails, the entire system must be disabled. The system is turned off automatically.
See also:
Radio transmitters and cellular telephones
Radio transceiver equipment (e.g.: etacs mobile phones, HAM radio systems and
the like) shall not be used inside the vehicle unless a separate aerial is mounted
on the roof.
IMPORTANT
The use of ...
Key-In-Ignition Reminder
Opening the driver’s door when the key is in the ignition and the ignition switch
position is OFF/LOCK, sounds a signal to remove the key. ...
If an exterior light burns out
For the type of bulb and power rating, see “When needing to change a bulb”. ...