To activate the Daytime Running Lights (DRL), rotate the end of the multifunction lever to the O symbol.
NOTE: The low beams and side/taillights will not be on with DRL.
The DRL function can be turned on or off using the display menus. Refer to “Electronic Vehicle Information Center (EVIC)” in “Understanding Your Instrument Panel” for further information.
See also:
16. Automatic Gearbox Failure
This light will illuminate when there is an automatic transmission fault. ...
Flash-To-Pass
You can signal another vehicle with your headlights by lightly pulling the multifunction
lever toward the steering wheel. This will turn on the high beams until the lever
is released. ...
Main beam headlights
To change the halogen bulb, proceed as follows:
1) Remove the protection cover Cfig.
18 turning it counterclockwise;
2) Release clip A-fig. 19, remove connector B and remove the bulb C.
...