Inspect the belt system periodically, checking for cuts, frays, and loose parts. Damaged parts must be replaced immediately. Do not disassemble or modify the system.
Front seat belt assemblies must be replaced after a collision. Rear seat belt assemblies must be replaced after a collision if they have been damaged (i.e., bent retractor, torn webbing, etc.). If there is any question regarding belt or retractor condition, replace the belt.
See also:
General instructions for using the seat belts
The driver is responsible for respecting and enforcing the local rules and laws
regarding the use of seat belts.
Always fasten the seat belts before starting.
For maximum safety, keep the back of ...
Controls
(A): Air temperature knob (mixing hot and cold air);
(B): Air recirculation on/off button;
(C): Fan knob and climate control system on/off;
(D): Air distribution knob. ...
Wind Stop
TheWind Stop installs in the backseat area of the vehicle.
The Wind Stop will not interfere with power top operation.
Therefore, it can remain installed when the top is up. ...