EOBD system

The EOBD system (European On Board Diagnosis) allows continuos diagnosis of the components of the car correlated with emissions.

It also alerts the driver, by the turning on of the warning light the message on the reconfigurable multifunction display (where required) (see section on the instrument panel together with the message on the reconfigurable multifunction display (where required) (see section “Warning lights and messages”), when these conditions are no longer in peak conditions.

The objective is:

❒ to keep system efficiency under control;
❒ warn when a fault causes emission levels to increase;
❒ warn of the need to replace deteriorated components.

The system has a diagnostic connector that can be interfaced with appropriate tools, which makes it possible to read the error codes stored in the control unit, together with a series of specific parameters for engine operation and diagnosis. This check can also be performed by traffic controller agents.

IMPORTANT After eliminating the inconvenience, to check the system completely, Fiat Dealership is obliged to run a bench test and, if necessary, road tests which may also call for a long journey.

If turning the ignition key to MAR, the warning light it turns on glowing steadily or flashing together with the message on the reconfigurable does not turn on or if, while travelling it turns on glowing steadily or flashing together with the message on the reconfigurable multifunction display (where required), contact Fiat Dealership as soon as possible. Warning light Uoperation can be checked by means of special equipment. Always comply with the traffic regulations in force in the country where you are travelling.

    See also:

    Engine Break-In Recommendations
    A long break-in period is not required for the engine and drivetrain (transmission and axle) in your vehicle. Drive moderately during the first 300 miles (500 km). After the initial 60 miles (100 ...

    Ceiling light
    With toggling lens To change the bulb, proceed as follows: ❒ remove the ceiling light by releasing the clipped on lens frame in the point shown by the arrow; ❒ open the containe ...

    To reduce memorised speed
    The speed memorised can be increased in two ways: ❒ disengaging the device and then memorising the new speed; or ❒ keeping the ring (B) pressed at (–) until reaching the new speed whi ...