With toggling lens
To replace a bulb:
1) Remove the ceiling light fig. 35 by releasing the clipped on lens frame in the point shown by the arrow.
2) Open the container A-fig. 36 and replace the burnt-out bulb.
With map reading lights
To replace a bulb:
1) Remove the ceiling light A-fig. 37 by releasing the clipped on lens frame in the point shown by the arrow.
2) Open the bulb container A-fig. 38.
3) Replace the burnt out bulb.
See also:
Folding front passenger seat
Folding the seat back
Lift lever A-fig. 54 to fold the seat back and obtain a tabletop.
Tipping the seat
To tip the seat and make more space in the passenger compartment proceed as follows:
– ti ...
“Dualdrive” electric power steering failure
Turning the ignition key to MAR the warning light on the dial turns on, but it
should go off after few seconds.
If the warning light stays on (on certain versions together with the message
on ...
Cellular phone set-up
The system set-up, combined with radio consists of:
❒ dual-purpose aerial (sound system + cellular phone 900/1800 MHz), on the car
roof;
❒ dual-purpose connection wires and ten-pin c ...