The towing device should be fastened to the body by specialized personnel according to any additional and/or integrative information supplied by the Manufacturer of the device.
The tow hitch must comply with the current regulation, with reference to Directive 94/20/EC and amendments.
Install a tow hitch which is suitable for the towing capacity of the vehicle.
Use a unified coupling for the electrical connections. The coupling is generally fitted on a specific mount fastened to the tow hitch.
For electrical connection, a 7 or 13 pole 12VDC coupling must be used (CUNA/UNI and ISO/DIN standards).
Follow the instructions provided by the manufacturer of the vehicle and/or the tow hitch.
Use the specific trailer light fuse box for electrical connections.
An electric brake should be supplied directly by the battery through a cable with a cross section of no less than 2.5 mm2.
In addition to the electrical connection, only the lead for powering an electric brake and the lead to power a light inside the trailer not exceeding 15W may be connected to the vehicle’s electrical system.
For connections use the preset control unit with battery cable no less than 2,5 mm2.
See also:
Rubber tubing
Follow the “Service Schedule” to the letter as concerns braking and fuel line
rubber tubing. Ozone, high temperatures and long absence of fluid in the system
can in fact cause the hardening and cr ...
Seat Height Adjustment
The driver’s seat height can be raised or lowered by using a lever, located on
the outboard side of the seat.
Pump the lever upward to raise the seat height, or pump the lever downward to
lower t ...
To open the bonnet
Proceed as follows:
❒ pull lever (A) in the direction of the arrow;
❒ press lever (B) as shown by the arrow;
❒ open the bonnet and release the rod (C) from its clip at th ...