Unbuckle the combination lap/shoulder belt and allow it to retract completely to disengage the Automatic Locking Mode and activate the vehicle sensitive (emergency) locking mode.
WARNING!
• The belt and retractor assembly must be replaced if the seat belt assembly
Automatic Locking Retractor (ALR) feature or any other seat belt function is not
working properly when checked according to the procedures in the Service Manual.
• Failure to replace the belt and retractor assembly could increase the risk of
injury in collisions.
See also:
FUEL LEVEL GAUGE
The needle indicates the amount of fuel left in the tank.The reserve warning
light (A) turns on (on certain versions together with the message shown on the reconfigurable
multifunction display) ...
General instructions
Wheel changing and correct use of the jack and spare wheel call for some precautions
as listed below.
Do not use the jack for loads over the value indicated on the plate.
The jack should only be ...
Refitting the standard wheel
Proceed as follows:
❒ Following the procedure described previously, raise the car and remove the
spare wheel;
❒ Make sure the contact surfaces between wheel and hub are clean so ...