1. Uncoil the Sealant Hose (6) (clear in color).
2. Locate the round Sealant Bottle release button in the recessed area under the sealant bottle.
3. Press the Sealant Bottle release button. The Sealant Bottle (1) will pop up. Remove the bottle and dispose of it accordingly.
4. Clean any remaining sealant from the TIREFIT housing.
5. Position the new Sealant Bottle (1) in the housing so that the Sealant Hose (6) aligns with the hose slot in the front of the housing. Press the bottle into the housing. An audible click will be heard indicating the bottle is locked into place.
6. Verify that the cap is installed on the fitting at the end of the Sealant Hose (6) and return the hose to its storage area (located on the bottom of the air pump).
7. Return the TIREFIT kit to its storage location in the vehicle.
See also:
Vehicle Storage
If you are leaving your vehicle dormant for more than 21 days, you may want to
take these steps to protect your battery.
• Disconnect the negative cable from the battery.
• Anytime you store your ...
To reduce memorised speed
The speed memorised can be increased in two ways:
❒ disengaging the device and then memorising the new speed;
or
❒ keeping the ring (B) pressed at (–) until reaching the new speed whi ...
Rear Park Assist — If Equipped
The Rear Park Assist system provides an audible indication of the distance between
the rear fascia/bumper and a detected obstacle when backing up, e.g. during a parking
maneuver. Refer to the “Par ...