1. Pull over to a safe location and turn on the vehicle’s Hazard Warning flashers.
2. Verify that the valve stem (on the wheel with the deflated tire) is in a position that is near to the ground.
This will allow the TIREFIT Hoses (6) and (7) to reach the valve stem and keep the TIREFIT kit flat on the ground.
This will provide the best positioning of the kit when injecting the sealant into the deflated tire and running the air pump. Move the vehicle as necessary to place the valve stem in this position before proceeding.
3. Place the transmission in PARK (auto transmission) or in Gear (manual transmission) and turn Off the ignition.
4. Set the parking brake.
See also:
Cooling System
WARNING!
• When working near the radiator cooling fan, disconnect the fan motor lead
or turn the ignition switch to the OFF position. The fan is temperature controlled
and can start at any time ...
How to warm up the engine after is has just started (petrol and diesel
versions)
– Begin to move forward slowly letting the engine turn at medium revs.
Do not accelerate abruptly.
– Do not push the engine to its limit for the first few kilometers. You are recommended
to wait u ...
Identification data
You are advised to note the identification codes. The identification data stamped
and given on the plates and their position are the following:
1 - Model plate
2 - Chassis marking
3 - Bodywork ...