Air comes from the floor outlets.
Aslight amount of air is directed through the defrost and side window demister outlets.
Bi-Level
Air is directed through the panel and floor outlets.
Press and release the Panel mode button and Floor mode button to enter Bi-Level mode, the indicators illuminate when ON. Performing this function will cause the ATC to switch into manual mode.
See also:
Number plate light
To change the bulb, proceed as follows:
❒ release the tab (A) and remove the cluster;
❒ turn the bulb holder (B) anticlockwise and remove the bulb (C). ...
Radio transmitters and cellular telephones
Radio transceiver equipment (e.g.: etacs mobile phones, HAM radio systems and
the like) shall not be used inside the vehicle unless a separate aerial is mounted
on the roof.
IMPORTANT
The use of ...
Accessories purchased by the owner
If after buying the car, you decide to install electrical accessories that require
a permanent electric supply (alarm, satellite antitheft system, etc.) or accessories
that in any case burden the ...