Emergency start-up

If the Fiat CODE system fails to recognize that code transmitted by the ignition key (instrument panel warning light on) the emergency startup can be performed by using the CODE card code. on) the emergency startup can be performed by using the CODE card code.

See section “In an emergency”.

Catalyzed vehicles must not be bump started (pushed, towed or coasted downhill)

Catalyzed vehicles must not be bump started (pushed, towed or coasted downhill) as this could cause fuel to flow into the catalytic exhaust system and damage it beyond repair.

power steering systems will not work and a greater effort will therefore be required Remember that until the engine has started the brake booster and hydraulic power steering systems will not work and a greater effort will therefore be required to depress the brake pedal or turn the steering wheel.

    See also:

    Fuse location
    The fuses of the car are grouped into two fuse boxes to be found respectively on the dashboard and in the engine compartment. Fuse box on the dashboard Loosen the two screws (A) and open the cover ...

    14. Electronic Throttle Control (ETC) Light
    This light informs you of a problem with the Electronic Throttle Control (ETC) system. If a problem is detected, the light will come on while the engine is running. Cycle the ignition key when t ...

    How To Disengage The Automatic Locking Mode
    Unbuckle the combination lap/shoulder belt and allow it to retract completely to disengage the Automatic Locking Mode and activate the vehicle sensitive (emergency) locking mode. WARNING! • The ...