Press
to turn this function on.
Activation is indicated by the turning on of the warning light
on the instrument panel.
This function is timed and switches off automatically after 30 minutes. To cut
out this function press again button
.
IMPORTANT Do not apply stickers on the inside of the rear window over the heating filaments to avoid damage that might cause it to stop working properly.
See also:
Stopping the engine
Turn the ignition to STOP while the engine is idling. IMPORTANT After a taxing
drive, you should allow the engine to “catch its breath” before turning it off by
letting it idle to allow the temper ...
Inflating procedure
Proceed as follows:
❒ Position the involved wheel with the inflation valve (A) set as shown in the
figure, then pull up the handbrake;
❒ Screw the filler hose (B) to the cylinder ...
Recline Adjustment
The recline adjustment lever is located on the inboard side of the seat. To recline
the seatback, lift up the recline lever, lean back until the desired position has
been reached, and release the ...


