The light should come on and remain on for four to eight seconds as a bulb check when the ignition switch is first turned ON. If the light is not lit during starting, see your authorized dealer. If the light stays on, flickers, or comes on while driving, have the system checked by an authorized dealer.
See also:
(C) Injecting TIREFIT Sealant Into The DeflatedTire
• Always start the engine before turning ON the TIREFIT kit.
NOTE: Manual transmission vehicles must have the parking brake engaged and the
shift lever in NEUTRAL.
• After pressing the Power Butt ...
Electronic control units
When the vehicle is being used normally, special measures are not necessary.
The following instructions must be followed very carefully, however, if you work
on the electrical system or in cases wh ...
With map reading lights
Press switch A-fig. 90 to switch the lights on and off.
Switch B operates the map-reading light.
According to the position, you can have the following conditions:
– switch A pressed at the centre ...