To change the bulb, proceed as follows:
1) Press the lens A-fig. 24 in the direction of the arrow so to compress the clip and remove the cluster.
2) Turn the bulb holder counterclockwise, remove the snap-fitted bulb and replace it.
See also:
CO2 emission at exhaust
The CO2 emission levels at the exhaust given in the following table refer to
combined consumption.
...
Accessories purchased by the owner
If after buying the car, you decide to install electrical accessories that require
a permanent electric supply (alarm, satellite antitheft system, etc.) or accessories
that in any case burden the ...
9. Air Bag Warning Light
This light will turn on for four seconds as a bulb check when the ignition switch
is first turned to ON/RUN. If the light is either not on during starting, stays
on, or turns on while driving, h ...