General instructions

– When a light is not working, check that it has not fused before changing the bulb.

– For the location of the fuses, refer to “If a fuse blows” in this chapter.

– Before replacing a bulb that does not work, check that the contacts are not oxidized.

– Burnt-out bulbs must be replaced with ones of the same type.

– Always check the height of the headlight beam after changing a bulb.

IMPORTANT

The headlight inner surface may be lightly misted over: this is not a fault but a natural fact due to low temperature and the level of air humidity. It will disappear as soon the headlights are turned on. The presence of drops inside the headlights means water infiltration, therefore contact Fiat Dealership.

    See also:

    Protection Of Body And Paint From Corrosion
    Vehicle body care requirements vary according to geographic locations and usage. Chemicals that make roads passable in snow and ice and those that are sprayed on trees and road surfaces during oth ...

    Central vents
    (A) - Air flow opening/closing control. ...

    Activation/deactivation (CITY function)
    To connect/disconnect the CITY function, push the button located on the central tunnel . Activation of this function is indicated by the word CITY on the instrument panel (see figures beside). ...