Right-hand stalk

Windscreen wiper/washer fig. 84

The device will only work when the ignition key is at MAR.

The device will only work when the ignition key is at MAR.

POSITIONS fig. 84

0 - windscreen wiper off;

1 - flick wipe; in some versions, four selections are possible (from slow to fast fig. 85);

2 - slow flick;

3 - fast continuous wipe

4 - Temporary position: when released the stalk returns to 0 and automatically switches off the windscreen wiper.

SMART WASH for rear window wiper fig. 86

SMART WASH for rear window wiper fig. 86

Pull the stalk towards the steering wheel to send a jet of fluid to the windscreen and operate the wiper with a simple gesture. The windscreen wiper will be operated automatically by holding the washer stalk for longer than half a second.

The windscreen wiper will flick three times after the lever is released.

Operate the control repeatedly and rapidly (for less than half a second) to spray the windscreen several times without operating the windscreen wiper.

Rear window washer/wiper (with glazed rear doors/tailgate) fig. 87-88

Rear window washer/wiper (with glazed rear doors/tailgate) fig. 87-88

The device will only work when the ignition key is at MAR.

To operate the rear window wipe:

turn the ring from To wash the window push the stalk towards the dashboard.

To wash the window push the stalk towards the dashboard.

SMART WASH for windscreen wiper fig. 88

Pull the stalk towards the steering wheel to send a jet of fluid to the rear window and operate the wiper with a simple gesture. The rear window wiper will be operated automatically by holding the washer stalk for longer than half a second.

The rear window wiper will flick three times after the lever is released.

The rear window wiper will flick three times after the lever is released.

    See also:

    Inflating procedure
    Proceed as follows: ❒ Position the involved wheel with the inflation valve (A) set as shown in the figure, then pull up the handbrake; ❒ Screw the filler hose (B) to the cylinder ...

    Stain Repel Fabric Cleaning Procedure – IfEquipped
    Stain Repel seats may be cleaned in the following manner: • Remove as much of the stain as possible by blotting with a clean, dry towel. • Blot any remaining stain with a clean, damp towel. • Fo ...

    Cold Weather Operation
    To prevent possible engine damage while starting at low temperatures, this vehicle will inhibit engine cranking when the ambient temperature is less than –22° F (–30° C) and the oil temperature se ...