The warning light on the dial comes on (on certain versions together with the message on the display) when a failure is detected to one of the following lights: taillights, brake lights (3rd stop light excluded), rear fog lights, direction indicators.
The failure referring to these lights could be: one or more blown bulbs, a blown protection fuse or a cutoff electric connection.
Symbols (where provided) coming on on the multifunction display indicate a left/right-hand light failure.
The warning light on the dial comes on (on certain versions together with the message on the display) when a failure is detected to one of the following lights: taillights, brake lights (3rd stop light excluded), rear fog lights, direction indicators.
The failure referring to these lights could be: one or more blown bulbs, a blown protection fuse or a cutoff electric connection.
Symbols (where provided) coming on on the multifunction display indicate a left/right-hand light failure.
See also:
Electronic control units
When the vehicle is being used normally, special measures are not necessary.
The following instructions must be followed very carefully, however, if you work
on the electrical system or in cases wh ...
Key Ignition Park Interlock
This vehicle is equipped with a Key Ignition Park Interlock which requires the
shift lever to be placed in PARK prior to rotating the key fob to the LOCK/OFF position.
The key fob can only be remov ...
Emergency start-up
If the instrument panel warning light
stays on with fixed light, the emergency
start-up can be performed by using the CODE card code (see section “In an emergency”). ...