
1. Sealant Bottle
2. Deflation Button
3. Pressure Gauge
4. Power Button
5. Mode Select Knob
6. Sealant Hose (Clear)
7. Air Pump Hose (Black)
8. Power Plug
Using The Mode Select Knob And Hoses
Your TIREFIT kit is equipped with the following symbols to indicate the air or sealant mode.
Selecting Air Mode

Turn the Mode Select Knob (5) to this position for air pump operation only. Use the Black Air Pump Hose (7) when selecting this mode.
Selecting Sealant Mode

Turn the Mode Select Knob (5) to this position to inject the TIREFIT Sealant and to inflate the tire. Use the Sealant Hose (clear hose) (6) when selecting this mode.
Using The Power Button

Push and release the Power Button (4) once to turn On the TIREFIT kit. Push and release the Power Button (4) again to turn Off the TIREFIT kit.
Using The Deflation Button

Press the Deflation Button (2) to reduce the air pressure in the tire if it becomes over-inflated.
See also:
Parking sensors (where provided)
Parking sensors are located in the rear bumper to detect and inform the driver
(through an intermittent acoustic signal) about the presence of obstacles behind
the vehicle.
ACTIVATION
Sensors wi ...
Raising The Power Top
From the convertible top fully open position, press the top close button for
approximately one second for the partially open position. Press the top close button
for approximately one second a sec ...
Passenger’s front air bag (where provided)
It consists of an instant-inflating cushion contained in a special recess in
the dashboard; its volume is bigger than the driver’s one.
The driver’s and passenger’s front Air bags have been desig ...


