The Hazard Warning flasher switch is located on the instrument panel below the radio.
Press the switch to turn on the Hazard Warning flashers. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flashers.
Do not use this emergency warning system when the vehicle is in motion. Use it when your vehicle is disabled and it is creating a safety hazard for other motorists.
If it is necessary to leave the vehicle to go for service, the Hazard Warning flashers will continue to operate with the ignition key removed and the vehicle locked.
NOTE: With extended use, the HazardWarning flashers may wear down your battery.
See also:
Restoring the use of the rear seat
Versions with single seat
Perform operations in a reverse order with respect to what previously described
for the boot extension operation. To prevent buckles from remaining positioned below
th ...
Flash-To-Pass
You can signal another vehicle with your headlights by lightly pulling the multifunction
lever toward the steering wheel. This will turn on the high beams until the lever
is released. ...
How to use the gears
Press the clutch fully before shifting the gear stick into one of the positions
shown in the diagram in fig. 2 (the diagram is also on the gear lever knob).
IMPORTANT
Only engage the reverse gear ...