When the shift lever is in the AutoStick position (to the left of the Drive position), it can be moved forward and rearward. This allows the driver to manually select the transmission gear being used. Moving the shift lever forward (-) triggers a downshift, and moving it rearward (+) an upshift. The gear position will display in the instrument cluster on the transmission range indicator.
NOTE: In AutoStick mode, the transmission will only shift up or down when the
driver moves the shift lever rearward (+) or forward (-), except as noted below.
AutoStick is deactivated when the shift lever is moved out of the AutoStick (+/-) position.
See also:
Extending the boot
Single rear seat
Proceed as follows:
❒ fasten the seat buckles to the tabs on the seat back (as shown by arrows);
❒ check that the webbing (A) of each of the two side seat belts is ...
EBD failure
(red) (amber)
The turning on at the same time of warning lights
with the engine running indicates an
EBD system failure or that the system is unavailable;
in this case heavy braking may cause ...
Fuel consumption
The fuel consumption figures given in the table below are determined on the basis
of the homologation tests set down by specific European Directives.
The procedures below are followed for measuring ...