EOBD system

The EOBD system (European On Board Diagnosis) allows continuos diagnosis of the components of the vehicle correlated with emissions.

Furthermore, the system warns the driver of deterioration concerning the emission system components by means of the light on the instrument panel. warning light on the instrument panel.

The objective is to:

– monitor system efficiency;

– warn when failures can increase emissions over the threshold established by the European regulations;

– warn of the need to replace deteriorated components.

Furthermore, the system is equipped with a connector for interfacing with specific tools used to read the error codes stored in the control unit memory along with a set of diagnostic and engine specific parameters.

Contact a Fiat Dealership as soon as possible if the

Contact a Fiat Dealership as soon as possible if the on when the key is turned to MAR or comes on, with fixed or flashing light, when warning light either does not come on when the key is turned to MAR or comes on, with fixed or flashing light, when traveling. Warning light can be checked by means of special equipment by traffic agents. Always comply with operation can be checked by means of special equipment by traffic agents. Always comply with the traffic regulations in force in the country where you are traveling.

IMPORTANT

After eliminating the problem, your Fiat Dealership will run a bench test to fully check the system.

In some cases, a long road test may be required.

    See also:

    Engine oil consumption
    Max engine oil consumption is usually 400 grams every 1000 km. During the beginning of the vehicle’s life the engine is be tuned in. Engine oil consumption can only be considered stabilized after t ...

    Windscreen/rear window washer fluid
    To top up, remove the cap A-fig. 12 and lift the telescopic filler B, until it clicks. Pour a mixture of water and TUTELA PROFESSIONAL SC 35, in the following concentrations: 30% of TUTELA PROFESS ...

    General Information
    This device complies with Part 15 of FCC rules and with RS-210 of Industry Canada. Operation is subject to the following conditions: 1. This device may not cause harmful interference. 2. This dev ...