Replacement Keys

to start the vehicle. Once a Sentry Key has been programmed to a vehicle, it cannot NOTE: Only keys that have been programmed to the vehicle electronics can be used to start the vehicle. Once a Sentry Key has been programmed to a vehicle, it cannot be programmed to any other vehicle.

At the time of purchase, the original owner is provided with a four-digit Personal Identification Number (PIN).

This PIN is required for authorized dealer replacement of keys. Duplication of keys may be performed at an authorized dealer. This procedure consists of programming a blank key to the vehicle electronics. A blank key is one which has never been programmed.

keys with you to an authorized dealer. NOTE: When having the Sentry Key Immobilizer System serviced, bring all vehicle keys with you to an authorized dealer.

    See also:

    Key with remote control
    Key (B) (or (D) in alternative), delivered together with key (A) or (C) when the car is fitted with remote control, controls the following: ❒ the ignition switch; ❒ the door and ...

    Lap/Shoulder Belt Operating Instructions
    1. Enter the vehicle and close the door. Sit back and adjust the seat. 2. The seat belt latch plate is along side the pillar near the back of your seat. Grasp the latch plate and pull out the belt. ...

    ESP system failure
    Turning the ignition key to MAR, the warning light on the dial comes on but shall go off after few seconds. If the warning light does not go off or stays on when travelling (on certain versio ...