For checking and restoring pressure only

The compressor can be also used just for restoring pressure. Disconnect the quick connection and connect it directly to the tyre valve; in this way the cylinder is not connected to compressor and the sealing fluid will not flow into the tyre.

Cylinder replacement procedure

    See also:

    If an accident occurs
    – It is important to keep calm. – If you are not directly involved in the accident, stop at least ten meters away from the accident. – If you are on a motorway, do not obstruct the emergency lane ...

    Additional braking light (third stop)
    To change the bulb, proceed as follows: ❒ open the tailgate and loosen screws (A); ❒ release the clip (B) and open the bulb holder, the remove the bulb (C) to be replaced (clippe ...

    Annual inspection schedule
    For cars with an annual mileage of below 20,000 km (for example about 15,000 km) the following yearly inspection programme is advised: ❒ check tyre conditions/wear and adjust pressure if req ...