Ceiling light

With toggling lens

With toggling lens

To change the bulb, proceed as follows:

❒ remove the ceiling light by releasing the clipped on lens frame in the point shown by the arrow;
❒ open the container (A) and replace the burnt-out bulb.

With map reading lights

To change the bulb, proceed as follows:

To change the bulb, proceed as follows:

❒ remove the ceiling light (A) as shown by the arrows;
❒ open the container (B) and replace the burnt-out bulb.

    See also:

    Button volume (Keys Volume)
    The volume of the roger-beep accompanying the activation of certain buttons can be adjusted according to 8 levels. The roger-beep can be adjusted and excluded. To adjust the volume proceed as foll ...

    Electrical Power Outlets
    There is a standard 12 Volt (13 Amp) power outlet, located in the floor console, for added convenience. This power outlet can power mobile phones, electronics and other low power devices. Powe ...

    Roof rack/ski rack
    PRESETTING To use the roof racks you shall remove the caps set in points fig. 136. Attach the roof rack bar brackets to the fasteners. IMPORTANT Always follow the instructions provided with the ki ...