The Sentry Key system complies with FCC rules part 15 and with RSS-210 of Industry Canada. Operation is subject to the following conditions:
• This device may not cause harmful interference.
• This device must accept any interference that may be received, including interference
that may cause undesired operation.
NOTE: Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
See also:
How to use the gears
Press the clutch fully before shifting the gear stick into one of the positions
shown in the diagram in fig. 2 (the diagram is also on the gear lever knob).
IMPORTANT
Only engage the reverse gear ...
Key-In-Ignition Reminder
Opening the driver’s door when the key is in the ignition and the ignition switch
position is OFF/LOCK, sounds a signal to remove the key. ...
Lap/Shoulder Belt Operating Instructions
1. Enter the vehicle and close the door. Sit back and adjust the seat.
2. The seat belt latch plate is along side the pillar near the back of your seat.
Grasp the latch plate and pull out the belt. ...