1. Remove the plastic cap from the back of the headlamp housing.
2. Rotate the bulb counter-clockwise.
3. Remove the bulb and replace as needed.
4. Install the bulb and rotate clockwise to lock in place.
5. Reinstall the plastic cap.
See also:
General Information
The Sentry Key system complies with FCC rules part 15 and with RSS-210 of
Industry Canada. Operation is subject to the following conditions:
• This device may not cause harmful interference.
• T ...
Adding Washer Fluid
The windshield washer fluid reservoir is located in the engine compartment, and
the fluid level should be checked at regular intervals. Fill the reservoir with
windshield washer solvent (not engin ...
Failure warnings
ABS failure
If warning light lights up together
with the message on the reconfigurable multifunction display (where provided) (see
section “Warning lights and messages”) this indicates a fault i ...