General Information

This device complies with Part 15 of the FCC rules and RSS 210 of Industry Canada. Operation is subject to the following conditions:

Х This device may not cause harmful interference.
Х This device must accept any interference received, including interference that may cause undesired operation.

The tire pressure sensors are covered under one of the following licenses:

    See also:

    Main beam headlights
    To change the halogen bulb, proceed as follows: 1) Remove the protection cover Cfig. 18 turning it counterclockwise; 2) Release clip A-fig. 19, remove connector B and remove the bulb C. ...

    Extending the boot
    Split seat Before setting off, make sure that the seats in the direction of travel and perfectly fastened to the anchoring. Only in this position can be seat belts be used correctly. The boot can ...

    Roof rack/ski rack
    FASTENERS 3-door versions Move the seal aside in the points shown in the figure to reach the fasteners. The rear fasteners are in the areas indicated by the printed reference mark O on the rear ...